Coreboot hacking: How to solder a PLCC socket on your board

Desoldering station.

When trying to port coreboot (previously LinuxBIOS) to a new mainboard you're often confronted with a big problem: the BIOS/ROM chip on the respective motherboard is soldered onto the board (i.e., not in a socket).

This means that you cannot easily (hot-)swap the chip during development or for recovery purposes. So you basically have exactly one try to flash the ROM chip with a fully working/booting coreboot image. If that goes wrong your board is bricked.

Desoldering the chip

This makes it pretty much impossible to develop a coreboot port for such boards (and soldered-on ROM chips are becoming more and more common, unfortunately).

However, I've recently tried to replace the soldered-on (PLCC) ROM chip on one of my boards with a socket. What sounds pretty scary at first, especially given that I have almost non-existant soldering skills, turned out to be really not that hard. Also, it can be done with relatively cheap and readily available equipment.

I have written a short HOWTO for desoldering chips and soldering on sockets in the coreboot wiki, and also finished a video showing most of the process, which I hope will be helpful for others:

Place the PLCC chip

The video is CC-BY-SA 3.0, music is taken from and is CC-NC 3.0 licensed. Video editing was done using Kino (which uses ffmpeg2theora for Ogg Theora export).

I also tried to upload the video to Vimeo, but first they told me to install the Flash 10 abomination (and there's no way I will do that). After browsing the help/forum pages a bit I found a traditional, non-flash upload form, but that then tells me that I cannot upload Ogg Theora videos. WTF?

Soldering the socket

The Ogg Theora video support feature request has been open for more that a year. Until that issue is fixed I'll just use other video services, thanks...

Syndicate content